Citiraj:
Autor calypso
Pa majkumupoljubim, kud 2018 remaster!? Ti moderni remasteri su svi grozno popeglani, to nekad stvarno grozno zvuci... Ajd da je neki digital remaster tamo iz 90ih ili pocetka 2000tih, u redu, ali ovi najnoviji koriste sve i svasta od tih 'naprednih' tehnologija za peglanje zvuka da na kraju dobijes uzas...
Ovdje ti je original...
https://www.youtube.com/watch?v=YF1R0hc5Q2I |
Meni to zvuči isto, ali ja sam, osim mentalno, i audiofilski podkapacitiran pa...
Nego, zašto KRK u svom
guideu kako postaviti subwoofer kaže ovo:
Citiraj:
Subwoofer volume and phase alignment
The next step is to configure the subwoofer volume and phase settings for your system. Here are
some step by step instructions:
- Start with your subwoofer crossover set to around 80Hz.
- Next, route a band-limited pink noise tone through the system, including the satellite
speakers (these test tones are available on the KRK website — see the download link on the
next page). 500Hz-1kHz will allow you to set the volume of the satellites without exciting
the subwoofer. Using an SPL meter (or smartphone app), set the overall volume so that
the level is something comfortable - around 85dB should suffice.
- Run another band-limited pink noise tone of 35Hz-70Hz through the system and set the
volume on the sub to where it’s hitting 85dB on the meter.
- Set the low pass crossover to the highest setting (near 130Hz). Run a band-limited pink
noise tone from 60Hz-120Hz, and from the listening position determine if 0 or 180 on the
phase switch is loudest. Leave the switch in the loudest position.
- If your subwoofer has a variable phase knob, run a 70Hz test tone through the system.
Flip the phase switch to either 0 or 180, whatever the opposite of the setting in the
previous step, and adjust the variable phase until the bass level is quietest. Then flip the
phase switch back to the previous setting.
- Finally, listen to some music you are familiar with and set the crossover level to a position
where you only hear lows and no mid frequencies from the subwoofer. A commonly
accepted practice is to double the lowest frequency that the satellite speakers are rated
for and use that as the crossover frequency.
|
Ja spojim UMIK-1 na PC, uključim SPL meter u REW-u i puštam 500-1kHz zvuk samo preko Adama (sub u bypassu), te pojačam da budu na ~75dB.
Zatim, prema njima, sada uključim sub, puštam zvuk 35-70Hz te ga pojačavam dok i on ne bude na ~75dB (volume knob na otprilike 1/5 rangea).
Po toj logici, Adami i sub bi se trebali jednako čuti, međutim kad pustim bilo koju pjesmu, sub se uopće ne čuje.
Treba ga znatno pojačati da bi se čuo.
Šta radim krivo?