CD-RW Firmware HELP!
 

da li se nekako moze izbrisati/presnimiti postojeci Firmware npr. noviji 1.13 i snimiti stariji 1.09! napravio sam zajeb, snimo sam pogresni Firmware, i sada zajebava! Help

mozes ga silovat :D

prosvrljaj tu http://forum.rpc1.org/portal.php

ok, nasao sam Firmware!
>>ALI NAPRAVIO SAM Sranje! SAada mi u windowzima uopce nece prepoznati ni przilicu ni dvd!
Sjebao sam ga sa Firmware ! Kak npraviti da mi prepozna , UPOCE NE MOGU UPAJDIRATI NOVE Firmware, KADA GA NE PREPOZNA (u Divice manegeru je nasao DVD i przu), ali ne mogu uopce upajdirati!
Help LJUDI, HHHHHEEEEEEEEELLLLLLLLLPPPPPPPPP!!!!

uspio sam narediti DVD, a jos samo przu, ali kako!
Evo vam da ubuduce znate :
>>Reconnect the jumper line on the rear panel of the Drive to SL(slave) position, and reposition other IDE device to Master.
All the devices shall be connected on the same cable.
If you have a CD-RW drive or a DVD-ROM drive besides Primary IDE HDD at Slave position, please re-connect the above drives to Master and connect the DVD-R/RW Drive on the same cable line.
Some HDD require jumper setting change when a drive is connected to the Slave position.
Please consult with the manual or check the relevant web site for the infomation.<<

Baš ti to hdjedoh reći. Dobro da si sam našao.

Lakže (li jedino moguće) ti je oživljavati CD-ove sa startupice. Dakle, nabavi program za flashanje iz DOS-a.

de mi reci kak da si sad sredim svoj teac 52x24x52x ? nigdje na netu ne mogu naci Firmware Update Failure for Teac, cak ni na njihovoj stranici?
koji programi se korise za Firmware Update iz dosa?