evo danas ne radim pa da napokon odgovorim,radim sve kako si napisao i neće, al ovako kad radim raid prego gigabyte controlera onda mogu napraviti raid ali nemogu volume ,a obično prvo nudi volume pa raid, ali napravio sam volume na njemu prilikom instaliranja viste ,jer mi je prepoznala raid i onda sam u samoj instalaciji viste u tom raid polju napravio volume i tu je instalirao (vistu)i kad se instalirala vista morao sam samo formatirati raid polje i sad je sve ok ,imam raid ,i volume na njemu.
ali kad želim na intelovom controleru instalirati raid ,dobijem normalno ovu opciju za napraviti volume i i stvorim ga bez problema i nakon toga nemogu nikako dobiti opciju koja sljedi za napraviti raid u raid biosu. dok kad sam prvi puta prije 10 dana radio prvi raid napravio sam ga baš na intel controleru, tako da me sad čudi da neće al ovo sigurno ima veze - kad skinem zadnji
Intel® Matrix Storage Manager i pokušam instalirati odbije mi instalciju uz obrazloženje da nemam minum requirements za instalaciju , a imam sve potrebno i sad čitam na srtanicamam intela piše-
Possible issues with Windows Vista* and Intel® RAIDThe following issues may occur on Windows Vista* with a
supported Intel® RAID Controller hub:
- Inability to install Windows Vista (i.e. system halts during installation)
- Performance degradation
- Timeout errors reported by iastor or iastor(v) in Microsoft Event Viewer*
Cause
A change was made by Microsoft* in the Windows Vista setup process. The result of this change is that the Intel® Matrix Storage Manager Link Power Management (LPM) registry settings that were intended for mobile installations are added for desktop installations as well. These LPM registry settings are added for both the Intel® Matrix Storage Manager RAID driver on the Windows Vista installation disk, as well as for any drivers added during the installation process.
Various desktop Serial ATA devices such as hard drives and CD/DVD drives have been reported that do not comply with the Serial ATA LPM device specification and display erratic behavior when LPM is enabled.
Because the setup change means that LPM is enabled by default for all Windows Vista platforms, using a device that does not completely follow the specification may result in one of the listed issues.
A list of these devices is not available at this time.
Solution
If you are experiencing installation issues, one of the following workarounds may help resolve the issue:
- If available, install updated firmware for the device.
- Switch to IDE mode in the system BIOS. Note: See your BIOS manufacturer for instructions on how to do this.
- Attach the device(s) to ports 3-5 on the Intel® 82801HR/HH/HO I/O controller hub (ICH8R) or port 3 on the Intel® 82801GR/GH I/O controller hub (ICH7R)
If you are experiencing performance degradation or timeout errors, one of the following workarounds may help resolve the issue:
- If available, install updated firmware for the device.
- Delete the iastor(v) Parameters registry key by using the following steps:
1. Go to Start » Search.
2. Type in RegEdit and hit the Enter key.
3. Go to HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\iaStor(v).
4. Right-click on the Parameters key under iaStor(v) and select the Delete option.
znači možda mi hardovi moraju biti baš tu spojeni-Attach the device(s) to ports 3-5 , a ne bilo gdje, jer baš imam vistu 32, možda su mi i bili kad sam prvi puta uspio naparaviti raid.
pa šta mislite ,moram probati al sad je 3 ujutro došao sam s posla pa ču sutra
i zašto mislite da je bolje imati raid u intel controleru a ne gigabyte i da je on smeće, samo pitam da znam i jel mi vista isto brže radi ako je instalirana u volumenu od raid polja ili čim je volume radi isto kao na bilo kojem drugom hardu?
hvala na pomoči
bok
