[jest]

ej.. imam isti problem kao i ti... da li bi mogao postati kako si ti konfigurirao svoj modem..

ovo je moj log

01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=33
01/01/1970 00:00:00> ATM: Setting up vcc1, VPI=0, VCI=33
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> CfgMgr: 'Shtm.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'ShtmMib.dlz' module loading failed.
01/01/1970 00:00:06> CfgMgr: 'Washer.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Apimage.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Prism.dlz' module loaded.
01/01/1970 00:00:18> ATM Connected
01/01/1970 00:00:18> ATM layer is up, cell delineation achieved
01/01/1970 00:00:18> ADSL connected
01/01/1970 00:00:18> Modulation: G.dmt
01/01/1970 00:00:18> Annex Mode: ANNEX_B
01/01/1970 00:00:18> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:18> CO Vendor: UNUSED_VENDOR_0
01/01/1970 00:00:18> d/s SNR: 26.8dB, u/s SNR: 23.0dB
01/01/1970 00:00:18> d/s Attenuation: 43.1dB, u/s Attenuation: 23.0dB
01/01/1970 00:00:18> d/s Data Rate: 1024kbps, u/s Data Rate: 256kbps
01/01/1970 00:00:18> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:18> d/s total bit capacity: 1292bits, used: 392bits
01/01/1970 00:00:18> u/s total bit capacity: 72bits, used: 72bits
01/01/1970 00:00:18> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:18> PPP1 PPPoE PADI Sent

vidim da imam nesto viska