Nekako sam skloniji upotrebi FLASHUP-a samo to nisam nikada radio a nisam siguran da pri sadašnjem stanju mogu flashati nešto što samo računalo ne prepoznaje.Što se tiće spajanja pinova 45-47 ,evo što sam našao na forumu :
"When I first connected the drive to my laptop (replacing the old Toshiba XM-7002B 24x CD-ROM drive), I noticed that the drive was detected as a slave device and since it is the only device on the secondary IDE bus, many functions were disabled (e.g. I could not boot to the drive or enable Ultra DMA). After many days of research I decided to try the method of shorting pins 47 and 45 as described in this thread:
http://forum.rpc1.org/viewtopic.php?...f7b1ca130bacf6
After this modification, the drive is detected as the secondary master, I am able to boot to it, and I can enable Ultra DMA (mode 2 IDE controller maximum). I thought that all of my problems were sloved until I ran Nero CD-DVD speed and attempted to play a DVD. The burst rate is capped at 1MB/s (less than 1x DVD). Any transfers faster than this burst rate max out the processor usage obvoiusly something is wrong. I have tested this in DOS, Windows 98, and Windows XP with the same results. Before blaming the processor (AMD K6-III+ @ 521 MHz) or the interface, I have tested these and the burst rate for the hard drive is no less than 30.8 MB/s and the CPU is able to play DVD files (VOBs) from the harddrive with no problem using PowerDVD. "
Kako god bilo zahvaljujem na trudu.