This is a must to add to the proper Cmos clear.
Dear customer:
1. Put CMOS jumper to the clear side (pins 2-3)
2. Remove CMOS battery
3. Unplug the power cord of the power supply
4. Use a screwdriver and short the inside metal plate of the battery holder
5. Put CMOS jumper back to normal
6. Press onboard easy power switch
7. Use a screwdriver and short the inside metal plate of the battery holder
8. Press onboard easy power switch
9. Put CMOS battery back
10. Plug power cord back
11. Make sure 24pins and 8 pins is properly connected to the motherboard and the video card is well seated firmly toward the board.
12. Start the system.
You should have at least CPU, memory and video firmly seated to the motherboard to do above test.
Ovako je pisalo, mislim na DFI-Streetu. Je se to bas mora tako il moze i nekako drugacije?