[andy91]

Hvala!

Ažurirao sam firmware od NVME adaptera ali nema nikakve promjene u brzini.
Znači li to da je USB bottleneck ili bi i preko USB NVME adaptera trebao imati veću brzinu?

I ovo sam pokušavao složiti, ali neće mi spojiti kao Driver=UAS

Dec 22 22:52:59 malina kernel: usbcore: registered new interface driver usb-storage
Dec 22 22:52:59 malina kernel: usb 2-1.4: UAS is ignored for this device, using usb-storage instead
Dec 22 22:52:59 malina kernel: usb 2-1.4: UAS is ignored for this device, using usb-storage instead
Dec 22 22:52:59 malina kernel: usb-storage 2-1.4:1.0: USB Mass Storage device detected
Dec 22 22:52:59 malina kernel: usb-storage 2-1.4:1.0: Quirks match for vid 152d pid 0583: 800000
Dec 22 22:52:59 malina kernel: scsi host0: usb-storage 2-1.4:1.0
root@malina:~# lsusb -t
/:  Bus 02.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/4p, 5000M
    |__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 5000M
        |__ Port 4: Dev 3, If 0, Class=Mass Storage, Driver=usb-storage, 5000M
/:  Bus 01.Port 1: Dev 1, Class=root_hub, Driver=xhci_hcd/1p, 480M
    |__ Port 1: Dev 2, If 0, Class=Hub, Driver=hub/4p, 480M
        |__ Port 1: Dev 3, If 0, Class=Hub, Driver=hub/4p, 480M
        |__ Port 3: Dev 4, If 0, Class=Vendor Specific Class, Driver=cp210x, 12M
        |__ Port 4: Dev 5, If 0, Class=Vendor Specific Class, Driver=ch341, 12M

A išao sam na ovu kombinaciju spajanja jer sam čitao da ako koristiš direkt NVME na rpi, može imati problema sa napajanjem.