Tema: 3D printeri
View Single Post
Staro 31.07.2024., 08:42   #345
tskarda
Premium
Moj komp
 
tskarda's Avatar
 
Datum registracije: Dec 2002
Lokacija: Umag
Postovi: 1,123
Citiraj:
Autor c-shadow Pregled postova
Ne znam baš za PTFE, ovo originalno mi se više čini da je malo viskoznije i nekako kao da je na bazi silikona.

https://forum.bambulab.com/t/where-t...cant-oil/33801
Imam fino mašinsko ulje od Singerice koju ženica koristi, ali tome ne znam sastav

Hm... idem dalje istraživati...
WD40 ima Silicone spray:

WD-40 Specialist® Silicone Lubricant safely lubricates, resists water and protects metal and non-metal surfaces such as rubber, plastic and vinyl. Once dried, this formula leaves a clear, non-staining film that doesn't stick or make a mess, so it won't attract dirt. This silicone lubricant spray is great for use on cables, pulleys, guide rails, valves, linkages, hinges, locks and more.

https://www.wd40.com/products/silicone-lubricant/

Nemam printer ali ga koristim gotovo svugdje gdje treba nešto podmazati.
tskarda je offline   Reply With Quote