[kopija]

If you have a Nvidia 20xx/30xx video card and you encounter micro stutter while using madVR
without actually dropping frames, please try the following:
◦ In the Nvidia control panel, go to Manage 3D Settings, scroll all the way down and set
Vertical Sync to 'On'. You can do this either globally or just for the media player exe.
◦ In the madVR settings, go to rendering -> general settings, and uncheck 'enable automatic
fullscreen exclusive mode'
◦ In the madVR settings, go to rendering -> windowed mode settings, and set 'how many
video frames shall be presented in advance' to 1 or a maximum of 3

Ali to je mačji kašalj naspram ove sramote:

Known limitations of Radeon RX 5000 and 6000 GPUs (older generations are fine):
• Hardware deinterlacing is broken in every driver version -> It is poor quality when applied to
interlaced video and it is not adaptive anymore, which is a NO-GO for HTPC usage.
You can check this issue yourself: Download this short MBAFF sample file
The Hardware Deinterlacer should be aware that the characters above "WWW.D88.COM" are
progressive and should not be deinterlaced, otherwise you will see flickering like in this picture
See here for more details
• Color levels (full 0-255 vs. limited 16-235) are broken. That means limited 16-235 which is the
standard range for videos are interpreted as 0-255 and this leads to elevated blacks and dimm
whites.
This issue can be best seen on displays which want full range 0-255, like TVs in PC Mode (PC
mode for full 4:4:4/RGB support, so you do not use color subsampling like 4:2:2 or 4:2:0)
Also overriding the range for test purposes in MPC-BE (video tab -> Output range) does not
take effect.
Dear AMD, if any of your driver programmers read this: Please fix this fundamental video
bugs .These are there since RX 5000 series launch.