Well a few problems sad.gif
Won't restart unless I shut off the power supply for about 4 minutes.
Got the vid card's down to 4-5C but no SLI still.
I enable it ...click apply....box pops up saying to make sure my
monitor is plugged into the primary card and restart....I click OK
and it takes the check mark out of the enable SLI box.
When it first goes into windows it says SLI ready click here to enable.
But it deos the samething I check enable SLI.....and OK
and it takes the check out?
Cpu's at below zero just don't know where blink.gif
bios says zero C at about -30-35 water temp vid cards were at 16C
water temp got down about -60 65F
Any idea's on the SLI or the shut down?
I have my monitor plugged into the top card.
it won't turn on in the bottom card?
Još na kraju kaže da će sve prodati i kupti 4800+ x2 i asus sli ploču.