Citiraj:
Autor btudan
Ima netko fleš i rukerneltool koji radi na 7490? Kombinacija koju imam mi javlja grešku da ga ne može flešati, a njemacki firmware mi nikako ne leži.
|
rukernel ne pomaže za 7490 jer autor rukernela više ne radi na aplikaciji. Ali, ima i jednostavnija kombinacija. Meni je prošlo bez problema.
Dobro prouči postupak pa kreni. Ako nešto i zezneš, samo ponavljaj onaj recover dok ne prođe.
Evo točno upute po kojima sam radio:
" Switch your PC to a fixed IP in the 192.168.178.0 network.
Disconnect the FritzBox from the mains.
Make sure nothing else but your PC is connected to the Fritz!Box (however is some cases it can help to have a switch between the Fritz!Box and your PC).
Open a MS-DOS Window and type ftp 192.168.178.1 (wait for the Enter).
Connect your FritzBox to the mains, and try to connect to the FTP server. It may take you several trials and errors to catch the correct time-frame.
Once connected to the FTP server, login with adam2/adam2.
Now type exactly the following lines:
quote SETENV firmware_version avme
quote REBOOT
The Fritz!Box will reboot now, and goes into an endless reboot loop. It looks like the FritzBox is broken. No panic, this is normal behaviour: the German Firmware will not load because we changed the "firmware_version" to avme
Now you can start the international recovery program and follow the instructions on your screen.
Do not forget to reset your PC to a dynamic IP (if needed)."
Ako ti nešto nije jasno, pitaj.