[vmzagreb]

neznam da li to može tu ili negdje drugdje ali imam pitanje vezano uz PCIx1 adapter za SATA diskove.


uzeo bih ovo:



da li ti adapteri podržavaju botanje sistema u raid soluciji dakle da ova dva diska vidim u windowsima kao jedan te da tako podržan disk bude i botabilan da se sa njega diže sistem.


Ovo je kopirano sa stranice:


PCI Express SATA 3 Controller Card, 2 Port PCIe SATA III 6GB/s Internal Adapter Converter for Desktop PC Support SSD and HDD w
material: metal
Colour: Black
Support Interface: USB3.0 TO SATA 22PIN
Support System: WinXP/Vista/Win7/Win8 32-bit/64-bit LINUX
Meets Serial ATA 3.0 specification, backward compatible with SATA2.0 SATA1.0
Compliant with PCI-Express v2.0 specification, backward compatible with PCI-Express v1.0.
Supports communication speeds of 6.0 Gbps, 3.0 Gbps, and 1.5 Gbps
Support Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x, and Gen 3i.
Supports two SATA
Support AHCI1.0 mode and IDE mode
Support native command queue (NCQ)
Supports FIS based on port multiplier switches or command switches.
Hot-swappable and hot-swappable.
Compatible with SATA6G, 3G and 1.5G Hard Drives
Bus interface
PCI-Express x1 slot
Extension ports
2 SATA3.0 interfaces
System Requirements
One available PCI Express X1 slot, supporting PCI-E X2 X4 X8 X16
Operating System: Windows 10/8/7 (32/64 bit) / Vista (32/64 bit) / XP/2003/2008/linux
System disk and PCIE to SATA3.0 adapter card connection conditions and solutions:
1, PCIE to SATA3.0 SATA interface mode is AHCI mode, if you want to insert the system disk in our card, the premise is that your system disk installed on the motherboard must be AHCI mode installation, otherwise it can not pass Our card adapter card boot system.
2. If it is determined that the system disk is inserted in the AHCI mode of the SATA interface mounting system on the mainboard, then the hard disk can be directly inserted into our card, and then the mainboard BIOS is set to start the system disk as the first boot.
3, the above two conditions are available, if you still can not start, or repeatedly restart, then the motherboard hard drive interface and our adapter card conflict, the solution is to enter the motherboard BIOS, the motherboard's hard disk interface options set to Disabled, save and restart to boot the system
Attention: Don't Support as System