View Single Post
Staro 02.03.2017., 14:02   #1
spitfire83
spava mi se
Moj komp
 
spitfire83's Avatar
 
Datum registracije: Nov 2013
Lokacija: Zagreb
Postovi: 329
Konfiguriranje vlan tagiranja na TPLINK-u s DDWRT-om

Uvedena mi je iskon optika. Imam reisecom ONT. Od iskona dobio zyxel vmg
Router je OK, ali ja bi ipak rađe stavia svoj TpLink TL-WDR4300 direktno u ONT.

Koliko sam skuzia i cita po forumu i ostatku interpleta, potrebno je tagirati wan port s vlan tagom 100 i podići pppoe konekciju.


U teoriji sam to i napravio, u praksi ne mogu podići PPPoE. Znam svoj username i password, a postavke u tplinku su ovakve:




A sama shema na routeru je ovakva:

eth0
the interface on which the switch is connected - is not used as layer 3 interface (has no ip-address). This interface is also used to configure the switch using the swconfig command.
vlan1
the logical interface that represents the LAN - is not used as layer 3 interface (has no ip-address).
vlan2
the logical interface that represents the WAN
br0
the logical interface for the complete LAN. This is the interface has the LAN-IP-Address.
Izvor: http://www.dd-wrt.com/wiki/index.php/TP-Link_TL-WDR4300


Što mi nedostaje, di fulam?
spitfire83 je offline   Reply With Quote