Citiraj:
Originally posted by SniperWolf
hoce li mi ovaj bios odgovarati ili da uzmem neki drugi?:confused: [list=a][*]02/07/2005 Beta SLI-DR/Ultra-D/SLI-D N4D702-3 (oskar wu beta)[/list=a]
eh da i dali moram downloackati sve na default (grafu..) kod promjene biosa?
|
Ne moraš(grafu)
Za memu ti je najbolje prepisati kaj je na njoj i poslati PM kućnom majstoru za to (Vedran.P) onda ćemo ti reći koji je najbolji BIOS.
Kod svakog flasha je osnovno čim flashas ući u BIOS i staviti sve na default vrijednosti, restartati i tek onda podešavati.
For the best guarantee that everything works properly:
Unplug the power cord to the computer to completely power down
clear CMOS jumper for 30 seconds
Power computer back up, and immediately go into the BIOS
Choose "Load Failsafe Defaults" or "Load Optimized"
Save and exit
Immediately after reboot, go back into the BIOS and configure to your liking
Clearing CMOS after a flash helps clear any old settings in the BIOS that might conflict with the new BIOS codes.
Always remember to completely power down the board by removing the computer's power cable or the motherboard's ATX power block plug before clearing the CMOS jumper. This is straight from DFI.
Here is the 'official' DFI way of clearing the CMOS:
every time you flash to a new bios, it is very important to clear the old BIOS settings out this way:
1. pull power
2. pull battery
3. clear cmos jumper for minimum of 30-60 seconds
4. replace cmos jumper to normal position
5. replace battery
6. replace power
7. boot to bios and load optimized defaults
8. save and exit
9. boot back to bios and now you can change settings to your liking.