jednom kad ju dobijes da boota napravi mem test, gpu test pa ces bit siguran na čem si
Kad ju dobiješ da boota, dal ti onda neko naredno vrijeme uvijek boota iz prve ili svaki put kad pališ zeza?
mene je jedna DFIca slično zezala. Zblesirala bi se prilikom promjena HW-a ili kada nestane struje, i to ne svaki put nego ono kak joj dode.
Znaci ona radi 5 mjeseci bez ikakve greške, nestane struje komp se zgasi. Kad ga krenem palit dobijem iste simptome kao i ti. Onda sljedi 3 dana zajebancije da ju dobijem da boota, a kad jednom zboota poslje toga opet radi mjesec, dva, tri, pet bez greške.
Popila mi je živaca i živaca jer je to nekad trajalo doslovce po tri dana. Radilo se o DFI LP Ultra-D ploči.
Ovako je to izgledalo bas sam zguglo, znaci čitava procedura + moras ju ponavljat dok ne uspije. C/P sa Anandtecha ne znam dal se smije stavit njihov link.
Vidi da nema nešto slično za tvoju plocu. Izgleda glupo al funkcionira, vec sam mislio bacit plocu nakon par dana agonije i onda naletim na ovo.
The dfi nf4 have a cold boot problem sometimes.. since you had it unplugged you might have to do a long cmos clear.
The following directions come directly from DFI tech support.
Remove power from the rig by pulling the plug or switching the PSU off.
Move the PC Speaker jumper to the ON position.
Remove the Battery.
Move the CMOS jumper to CLEAR.
Press the Start Button on the case or motherboard to drain the capacitors.
You may leave the board in this condition for as long as it takes to clear the CMOS. If a short 30 second clear or a 15 minute clear doesn't work, try an 8 hour clear then a 24 hour clear.
Plug in a PS2 Keyboard.
Put one stick of RAM in the top orange slot marked DIMM2.(may vary on Infinity boards)
Replace the Battery.
Move the CMOS jumper to Normal.
Press and hold the Insert Key on the Keyboard.
Apply power to the rig by plugging the power in or using the switch on the PSU.
Press the Start Button to power the rig up.
When you hear the BEEP, release the Insert Key and press the Delete Key on the Keyboard.
Once you enter the BIOS set the DATE and TIME then Load Optimized Defaults.
Save and Exit.
Enter the BIOS again and set it up the way you want for your particular rig.
NEVER load any saved CMOS settings from CMOS Reloaded once you have a new BIOS installed