Možda da probaš ovo sa jumperima, ako već nisi
http://wdc.custhelp.com/cgi-bin/wdc....p?p_faqid=1340 OPT1
jedan od odgovora dole, naveden je činimi se taj via-in kontroler, iako on kažu da je to kad uopće ne radi
Citiraj:
Problem:
Second Generation Serial ATA (SATA II) hard drives are not detected when connected to a VIA or SIS Serial ATA controller. These First Generation Serial ATA (SATA I) controllers include the following chipsets:
- VT8237
- VT8237R
- VT6420
- VT6421L
- SIS760
- SIS964
Cause:
Our SATA II hard drives use autospeed negotiation. This enables our SATA II drives to automatically detect the motherboard data transfer rate, making it backward compatible with SATA I data transfer rates. However, some older SATA I controllers are unable to support autospeed negotiation and cannot recognize the drive. This “drive not detected” condition occurs when a chipset is incapable of correctly negotiating the data transfer speed with a SATA II hard drive.
Resolution: - You can purchase and install a third party PCI or PCI-Express Second Generation Serial ATA controller card for your Serial ATA hard drive(s).
- To lock the drive at 150 MB/s data transfer rate install a jumper shunt on pins 5-6 (OPT1), shown in the picture below. (Only available on 3.5 inch (Desktop) size drives)
- If the OPT1 jumper setting does not resolve the issue, please contact Western Digital Support for further troubleshooting. See Answer ID 1048: How to contact Western Digital for support (email or phone). OPT1 Enabled:
|