PC Ekspert Forum - View Single Post - (riješeno) MSI Mega Book M677

xxx3xxx · 29.11.2009., 15:21

grafa je geforce 7600 nije integrirka, bas sam krenuo probati sa eksternim monitorom ali neznam dali ce ga odmah prebaciti na taj monitor, zvuka nikakvog nemogu dobiti.

EDIT:

evo ga digne sustav i sve. lcd 0 bodova, prebacivanje na externi sa DVI isto 0 bodova.. Netko s idejom?

EDIT:

Look at the LCD screen very closely and check if you can see a faint image on the screen. It’s possible that the LCD lid close switch stuck in the “closed” position and the backlight stays off even when you open the LCD screen or turn on the laptop. The switch turns off the backlight when you close the LCD display to save the laptop battery power. Check the LCD lid close switch. Usually it is a small plastic pin located close to the LCD hinges. Try to tap on the switch a few times to turn on the backlight. If after tapping on the LCD lid close switch the backlight stays on, you fixed the problem.
It is also possible that after tapping on the LCD lid close switch the backlight works fine, you see a normal video on the screen for some time and then the backlight turns itself off again. In this case I would blame the FL inverter board. Try to reseat cables on both end of the FL inverter to make a better contact between the cables and the FL inverter board. If it doesn’t help I would try to replace the FL inverter board.

Pronašao sam ovo pa ću probat!

EDIT:

Ali onda bi mi ga trebao prebaciti kad ustekam dvi.. Ili nebi.. dali automatski treba prebaciti ili se to namjesti u control panelu?

29.11.2009., 15:21	#3
xxx3xxx Premium Moj komp Datum registracije: Dec 2008 Lokacija: zAGREB Postovi: 35	grafa je geforce 7600 nije integrirka, bas sam krenuo probati sa eksternim monitorom ali neznam dali ce ga odmah prebaciti na taj monitor, zvuka nikakvog nemogu dobiti. EDIT: evo ga digne sustav i sve. lcd 0 bodova, prebacivanje na externi sa DVI isto 0 bodova.. Netko s idejom? EDIT: Look at the LCD screen very closely and check if you can see a faint image on the screen. It’s possible that the LCD lid close switch stuck in the “closed” position and the backlight stays off even when you open the LCD screen or turn on the laptop. The switch turns off the backlight when you close the LCD display to save the laptop battery power. Check the LCD lid close switch. Usually it is a small plastic pin located close to the LCD hinges. Try to tap on the switch a few times to turn on the backlight. If after tapping on the LCD lid close switch the backlight stays on, you fixed the problem. It is also possible that after tapping on the LCD lid close switch the backlight works fine, you see a normal video on the screen for some time and then the backlight turns itself off again. In this case I would blame the FL inverter board. Try to reseat cables on both end of the FL inverter to make a better contact between the cables and the FL inverter board. If it doesn’t help I would try to replace the FL inverter board. Pronašao sam ovo pa ću probat! EDIT: Ali onda bi mi ga trebao prebaciti kad ustekam dvi.. Ili nebi.. dali automatski treba prebaciti ili se to namjesti u control panelu? Zadnje izmijenjeno od: domy_os. 30.11.2009. u 09:44.