PC Ekspert Forum - View Single Post - Pitanja vezana za OC

Tumor · 15.07.2009., 01:42

Procitaj ovo:

http://tinyurl.com/nmqnhq

Njima je na testiranju Gigabyte EP45-DS3R voltaza na Auto otisla poprilicno visoko. Mozes cak vidjeti i na koliko, ali ne znam kako je to kod Asusa.

Ja sam za sad sve te "druge voltaze" stavio na minimum, pa cu polako dizati kada budem nailazio na nestabilnosti.

Ovo je zanimljiv dio:

BUT, against our better judgement we allowed all of the stress tests to run even though the auto settings of the board set VTT and PLL voltages at very dangerous levels, 1.60v and 1.85v respectively. We should add here that it has been commonly shared and concluded in the PC industry that 1.4v is about the maximum safe 24/7 voltage for VTT. However, it has come to our attention that some motherboard manufacturers have changed this limit to closer to 1.9v VTT. We will ask Gigabyte for an official answer and discuss this in the comment thread. All hardware appears undamaged but unless otherwise advised, we highly recommend against using auto settings for PLL and VTT voltages.

15.07.2009., 01:42	#532
Tumor prof.dr. gospodar svemira Moj komp Datum registracije: Nov 2003 Lokacija: Zagreb Postovi: 414	Procitaj ovo: http://tinyurl.com/nmqnhq Njima je na testiranju Gigabyte EP45-DS3R voltaza na Auto otisla poprilicno visoko. Mozes cak vidjeti i na koliko, ali ne znam kako je to kod Asusa. Ja sam za sad sve te "druge voltaze" stavio na minimum, pa cu polako dizati kada budem nailazio na nestabilnosti. Ovo je zanimljiv dio: BUT, against our better judgement we allowed all of the stress tests to run even though the auto settings of the board set VTT and PLL voltages at very dangerous levels, 1.60v and 1.85v respectively. We should add here that it has been commonly shared and concluded in the PC industry that 1.4v is about the maximum safe 24/7 voltage for VTT. However, it has come to our attention that some motherboard manufacturers have changed this limit to closer to 1.9v VTT. We will ask Gigabyte for an official answer and discuss this in the comment thread. All hardware appears undamaged but unless otherwise advised, we highly recommend against using auto settings for PLL and VTT voltages.