evo uspio sam FSB 570 postignut...ali trebalo bi to još ići kad sam vidio da od timmy-a poteže preko 600
pa ako mi može netko još pomoći oko, postavki bios je 2101
Citiraj:
AI Overclock tuner: Manual
CPU Ratio Setting: 6
FSB Strap to North Bridge: 333
FSB Frequency: 560
PCI-E Frequency: 100
DRAM Frequency:
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual
1st Information :
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: AUTO
Write Recovery Time: AUTO
Read to Precharge Time: AUTO
2nd Information :
READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO
3rd Information :
WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Enable
AI Clock Twister: lighter
AI Transaction Booster: manual
Common Performance Level: 10
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED
CPU Voltage: 1.5000
CPU GTL Voltage Reference (0/2): 0.615
CPU GTL Voltage Reference (1/3): 0.656
CPU PLL Voltage: 1.52
FSB Termination Voltage: 1.30
DRAM Voltage: 2.4
NB Voltage: 1.4
NB GTL Reference: auto
SBridge Voltage: 1.20
PCIE SATA Voltage: auto
Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : 400ps
NB Clock Skew : 400ps
CPU Margin Enhancement Optimized
|
]
