[thopok]

Assigning a new IP address to the SpeedTouch™

Under IP Addresses:

1 Type the IP address of your choice (for example 192.168.1.1) in the left text box.

2 Type subnet mask in the right text box (for example 255.255.255.0).

3 Click Add.

4 Network devices using the same subnet mask can now access the SpeedTouch™ using this IP address.

DHCP Pool

This page allows you to create/change a DHCP pool.
Accessing the DHCP Pool page

Proceed as follows:

1 On the Home Network menu, click Interfaces.

2 Click on the name of the interface of which you want to change the DHCP pool settings.

3 Click Configure.

4 Under DHCP Pools click:

Add if you want to add a new DCHP pool.

Edit if you want to edit an existing DHCP pool.

Delete if you want to delete an existing DHCP pool.


This link will only be shown if there are more than one DHCP pools.

The DHCP Pool page

Following settings are available for configuration:

Interface:
The SpeedTouch™ interface for which the DHCP pool applies.

Start Address:
The start IP address of the DHCP server’s address pool.

End Address:
The end IP address of the DHCP server’s address pool.


Both the start and end IP address define the IP address range used by the DHCP server to assign leases.

Subnet Mask:
The subnet mask of the DHCP server’s address pool.

Server:
The SpeedTouch™ IP address used as DHCP server address.

Gateway:
The IP address that will be assigned to the DHCP clients as their default gateway.

Primary DNS:
The IP address of the primary DNS server.

Secondary DNS:
The IP address of the secondary DNS server.

Primary WINS:
The IP address of the primary WINS server.

Secondary WINS:
The IP address of the secondary WINS server.

Lease Time:
The time for which the DHCP client is allowed to use the assigned IP address:


If Always give same address to DHCP clients the lease time will be automatically set to Infinite.

Always give same address to DHCP clients:
Select this check box if you always want to use the same IP address for the DHCP clients.

Usput ima li gdje opcija edit postojećih postavki za DHCP pool? Ja bi samo umjesto gateway-a .1.1 stavio .50.1

Zanimljivo, trebala bi postojat stranica(ali ovisi i o verziji firmware-a)

Add if you want to add a new DCHP pool.

Edit if you want to edit an existing DHCP pool.

Delete if you want to delete an existing DHCP pool.


This link will only be shown if there are more than one DHCP pools.

Kad stavim na pc-u ručne tcp/ip postavke ( sa 192.168.50.1 )

Start Address:   192.168.50.x
End Address:     192.168.50.y
Subnet Mask:     255.255.255.0
Server:          192.168.50.1
Gateway:         192.168.50.1
Primary DNS:     192.168.50.1
Secundary DNS: 
Primary WINS:
Secondary WINS:
Lease Time:      Infinite

x, y – željeni range(npr. 100, 200)
DNS – ili neki drugi željeni