Evo stabilno na
400Mhz FSB
Code:
Thermal Management Control.......... - Enabled
PPM(EIST) Mode...................... - Disabled
Limit CPUID MaxVal.................. - Disabled
CIE Function........................ - Disabled
Execute Disable Bit................. - Disabled
Virtualization Technology........... - Enabled
Core Multi-Processing............... - Enabled
>DRAM Timing:
Enhance Data transmitting........... - Normal
Enhance Addressing.................. - Normal
T2 Dispatch......................... - Auto
>Voltage Settings:
CPU VID Special Add................. - + 100.0mV (vdroop 1.296v)
DRAM Voltage Control................ - 1.957v
SB Core/CPU PLL Voltage............. - 1.75v
NB Core Voltage..................... - 1.2200v (vdroop 1.18v)
CPU VTT Voltage..................... - 1.14v (vdroop 1.10v)
Clockgen Voltage Control............ - 3.45v
CPU GTL0/2 REF Volt................. - 0.67x
CPU GTL 1/3 REF Volt................ - 0.67x
North Bridge GTL REF Volt........... - 0.58x
FSB Vref............................ - 2A
Genie BIOS Settings:
Exist Setup Shutdown................ - Mode 1
Exist Shutdown After AC loss........ - Disabled
O.C Clock Fail Retry Counter........ - 0
O.C Clock Fail CMOS Reloaded........ - Disabled
CPU Clock Ratio..................... - 9
Target CPU Clock.................... - 3600MHz
CPU Clock........................... - 400
Boot Up Clock....................... - Auto
CPU Clock Amplitude................. - 800mV
CPU Clock0 Skew..................... - 0ps
CPU Clock1 Skew..................... - 0ps
DRAM Speed.......................... – Auto
Target DRAM Speed................... - 960MHz
PCIE Clock.......................... - 101mhz
CPU Spread Spectrum................. - Disabled
PCIE Spread Spectrum................ - Disabled
Sada spuštam komponentu po komponentu, ali mislim da je problem ili u PLL-u ili u memorijskom djeljitelju.