Citiraj:
Autor summus
(Post 1475289)
....a kada ne ide ni tako?
http://slike.hr/slike-male/c/ccc_d8996.png
...pa niti u Partition Magicu nemogu ništa...
http://slike.hr/slike-male/a/aaa_ca452.png
Uvijek isto kao i u Disk Menegmentu mogu izbrisati taj Dynamic i nakon toga sve što mogu napraviti je ponovno "napraviti" taj Dynamic i tako u krug - Basic nikako...
Vidim da ovom izgleda nema riješenja, pa ću pitati vezano uz ovo što mi je najbitnije a to je spašavanje podataka: Ako prebacim podatke sa HDD-a koji je postao "nevidljiv" (HEKSAHEMERON) na ovaj novi HDD (DATA) koji je svojevoljno odlučio biti Dynamic, i što mu sad ja mogu:D... da li ću poslije kada reinstaliram windowse moći pristupiti tim podatcima ili bi se i to moglo iskomplicirati?
|
http://forum.pcekspert.com/showthread.php?t=140282
Citiraj:
HOWTO: Convert a dynamic disk back to a basic disk without data loss
**Disclaimer: This ONLY works if you have NOT used ANY of the "new" features of dynamic disks such as extending a partition or software RAID. This is an expert-level procedure, so if you don't know what you are doing, you shouldn't be attempting this.**
1) Install dskprobe.exe on the system. (This is one of the utilities in the Win2K or WinXP support tools on the install CD, and can be installed by simply copying the .exe file to the hard drive.)
2) Run dskprobe.exe on the system.
3) Select the Drives menu and "Physical Drive. . ."
4) Double click on the drive that you want to convert back to a basic disk. Click the "Set Active" button next to that drive.
5) From the Sectors menu, select "Read"
6) Accept the defaults (begin sector 0, read 1 sector) and click "Read"
---------------------------------------------------------------------------------------------------------------------------
7) In the editor, go to the "01C0" line and the third bit should be a "42".Change that to a "07".
---------------------------------------------------------------------------------------------------------------------------
8 ) From the Sectors menu, select "Write". Confirm all dialog boxes. **Note: This is the step that will hose your box if you have not followed the above instructions correctly.**
9) Exit dskprobe.exe. Reboot
10) Run chkdsk on the affected logical drive(s). If any errors are found, do a chkdsk /f to fix them. Done.
|
A koliko vidim u tome bi mogao pomoci i "Acronis True Image 9.1 Server/Enterprise Server." ? |
