Citiraj:
Autor ChP3
Nece, nema šanse ! 
Svaki puta kada palim komp (komp se ne budi).
Moram vaditi memoriju iz utora, miješati slotove
i onda proradi. Možda je do napajanja. Mema radi na 2.2v.
Sve sam poštelao oko latencija kako je LUXX, napisao ali ... štanga  |
netreba ti 2.2V
Evo još jednom sa mushkinovog foruma:
Citiraj:
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : 4-5
Row Refresh Cycle Time: 60(55-60)
Write Recovery Time: 6(5-6)
Read to Precharge Time: 4(2-4)
READ to WRITE Delay (S/D): 9(7-10)
Write to Read Delay (S): 4(3-4)
WRITE to READ Delay (D): 5
READ to READ Delay (S): 6(4-6)
READ to READ Delay (D): 6
WRITE to WRITE Delay (S): 5(4-5)
WRITE to WRITE Delay (D): 6
WRITE to PRE Delay:14(13-14)
READ to PRE Delay: 6
PRE to PRE Delay: 1
ALL PRE to ACT Delay: 6
ALL PRE to REF Delay: 6
DRAM Static Read Control: Disabled(Try enabled too)
DRAM Read Training: Auto
MEM. OC Charger: Auto
AI Clock Twister: Lightest
AI Transaction Booster: Manual
Common Performance Level: 9(5-7 may also be possible, lower results in better performance normally)
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED
DRAM Voltage: 2.0-2.1v
|
Isprobavaj.
Povisi sve sekundarne pa probaj sve niže i niže