Evo probo sam clockat proc, pa mi se desilo to da mi komp radi, ali je ekran zacrnjen..tj nista na njemu..to sam radio po ovome:
ASUS Maximus II Formula Q9550
Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8.5
FSB Frequency : 444
CPU Clock Skew : a
North Bridge Clock Skew : a
FSB Strap to North Bridge : a
DRAM Frequency: DDR2-1067
Dram Clock Skew CH1 A1 :a
DRAM Clock Skew CH1 A2 :a
Dram Clock Skew CH1 B1 :a
Dram Clock Skew CH1 B2 :a
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : 4
Row Refresh Cycle Time : 55
Write Recovery Time : 6
Read to Precharge Time : 5
Read to Write Delay (S/D) : 10
Write to Read Delay (S) : 4
Write to Read Delay (D) : 5
Read to Read Delay (S) : 6
Read to Read Delay (D) : 6
Write to Write Delay (S) : 5
Write to Write Delay (D) : 6
Write to PRE Delay : 14
Read to PRE Delay : 6
PRE to PRE Delay : 1
ALL PRE to ACT Delay : 6
ALL PRE to REF Delay : 6
DRAM Static Read Control: Enabled
Dram Read Training : AUTO
MEM OC Charger : AUTO
Ai Clock Twister : moderate
Transaction Booster : a
Common Performance Level a=5
Pull-In of CHA PH1 Disabled
Pull-In of CHA PH2 Disabled
Pull-In of CHA PH3 Disabled
Pull-In of CHA PH4 Disabled
Pull-In of CHA PH5 Disabled
Pull-In of CHB PH1 Disabled
Pull-In of CHB PH2 Disabled
Pull-In of CHB PH3 Disabled
Pull-In of CHB PH4 Disabled
Pull-In of CHB PH5 Disabled
PCIE Frequency : 100
CPU Voltage : 1.25
CPU PLL Voltage : 1.53
FSBT : 1.33850
DRAM Voltage : 2.1
North Bridge Voltage : 1.37
South Bridge Voltage 1.5 : 1.5
South Bridge Voltage 1.1 : 1.1
GTL 0 =a
GTL 1 =+20
GTL 2 =a
GTL 3 =+20
A poslije sam probo samo proc dignut, pa mi kad udjem u same winse, izbacivalo blue screen