Joj ljudi ja ću se upucat!
Evo kako ispadne modanje VF700Cu u Australiji!
Lik je kao to radio gledajuć moj post i moje slike....no problem je kaj je lik vjerojatno gledal te slike sa bar 5 promila u krvi jer ovo nije niti slično mojem mod-u
P.S. ploče su iste (obe Ultra-D)
Evo copy paste
I put on the Zalman VF-700cu vga heatsink on my nf4 Ultra-D as showen in this previous thread.
http://www.dfi-street.com/forum/sho...29&page=1&pp=15
I did this to get lower temps. My stock cooler had a buzzing noise that eventually went away. It fits under a 7800gtx in the 16x slot but needs some of the back fins chopped off and filed down as low as the stock cooler. The front fins need to be bent around the usb, sata and some capacitors. They could be filed back underneath until they clear everything without bending them.
I used AS5 TIM but after putting the heatsink on I rebuilt into a different case that has a side panel fan so I cant tell how much temperature has dropped. I think about 5c atleast. With the side fan turned on chipset temp has been down to 38c which is 10c lower than my previous lowest temps with the old case/heatsink.
Here are pictures, all about 900kb each.
http://img458.imageshack.us/img458/9...inplace5mr.jpg
The Zalman sitting in place without screws. This is when I had finished bending the fins away from the usb's etc.
http://img72.imageshack.us/img72/2830/finished3gq.jpg
The finished heatsink. The videocard goes across the lowest part that I filed back. The fins in the middle did not need cutting as much as I have done.
http://img74.imageshack.us/img74/614/78006yx.jpg
With 7800gtx in 16x slot. This is before I finished bending the fins.
http://img56.imageshack.us/img56/760/7800back8eq.jpg
The back of the 7800
http://img56.imageshack.us/img56/760/7800back8eq.jpg
http://img490.imageshack.us/img490/8...orechop6qv.jpg
Before I bent and chopped it.
E to je fakat kak bi Jelc reko KOVAČIJA!