OK, I flashed bios with new version an714.exe. Reboot and no more problem with boot. Nice and clear boot. Boot when computer is warm and cold is good, no problem. But no I have problem with stability of Windows. SOmetimes BLUS SCREEN. I did not change latency of memory. But now when I change in bios latency by SPD i get 2.5 3 3 8. Before it was 3 5 5 10. That means that bios read wrong latency form DDR RAM. I read somewhere that my memory couldnt work on 400MHz by 3 only on 333 MHz can 2.5. I think that i would change latency to 3 5 5 10 on 400 MHz and see what will happend. Iwould like to put CPU on 400 to make same with RAM. SOmething like 200x9=1800MHz. Is that OK. Do I need to change voltage(now 1.65V)?. Just to test it, maybe will work with same FSB. Just in mind I didnt buy this computer to play games or somthing else with hard work for computer, only for internet, movies, office work, easy stuff. Thx guys for help
Novo nije uvijek I najbolje. Flash biosa i vise nema problema sa bootanjem. Ocito da je bio problem i kod maticne i kod rama. Nekako su nespojivi. Prije dva dana mi je tip u servisu rekao da KingMax i Abit ne idu. Uvijek problemi. Errrrr. Sto mi to prije nije rekao. jos samo da rijesim postavke latencija. Nekako mi je cudno da bios cita sa novom verzijom BY SPD 2.5 3 3 8, a sa prijasnjom 3 5 5 10. Nekako mi to ne stima. Probat cu sa malo konzrevativnije 3 5 5 10 na 400. Vidim u biosu da mogu mijenjati multilikatore i FSB. Mislio sam na 200x9= 1800,koliko voltaza 1.7V? Nisam neki hardcore zagrizeni, htio bih samo stabilno racunalo. Hvala momci...