Mislio sam da moze promjenit jer se je na hardwareskim 56K modemima to uredno moglo mjenjat pomiću AT komandi.
Al izgleda na ovom nivou settinga da se ne moze mjenjat , nisam uspio nać, osim podatka kolika je pod" ADSL ".
Zanimljivo je da ti je duplo bolji SNR za upload nego meni.
Sad sam skuzio da vrijednosti atenuacije modem postavlja sam ovisno o stanju linije , i kad sam se ponovno spojio nisu više iste. SNR je tu negdje.
By the way i meni puca kad se pokrene update firmware-a. I onda treba zgasit modem.
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
01/01/1970 00:00:17> u/s total bit capacity: 72bits, used: 72bits
01/01/1970 00:00:17> d/s total bit capacity: 2149bits, used: 296bits
01/01/1970 00:00:17> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:17> d/s Data Rate: 1024kbps, u/s Data Rate: 256kbps
01/01/1970 00:00:17> d/s Attenuation: 28.0dB, u/s Attenuation: 14.0dB
01/01/1970 00:00:17> d/s SNR: 36.6dB, u/s SNR: 13.0dB
01/01/1970 00:00:17> CO Vendor: UNUSED_VENDOR_0
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> Annex Mode: ANNEX_B
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:06> CfgMgr: 'Prism.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Apimage.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Washer.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'ShtmMib.dlz' module loading failed.
01/01/1970 00:00:00> CfgMgr: 'Shtm.dlz' module loaded.
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=33
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> Ethernet Device 0 Detected
Citiraj:
Autor Veki-os
"Mozda se mozes i igrat da download atenuacijom"
Možeš mi reči gdje da ovo nađem,nisam uspio nači?
A ovo ču probati očistiti sutra s alkoholom,sad mi svi spavaju pa da ne rondam  |
