Evo moj log , modem radi OK:
Usporedi malo, ja sam ga tek sad uspio setirat da udjem u settinge:
BootCode Version: BC_CX82xxx_4.1.0.21
Firmware Version: CX82xxx_4.1.0.21
Customer Software Version: 4.1.0.2.1(B)_SIE_CRO_03
01/01/1970 00:00:00> Ethernet Device 0 Detected
01/01/1970 00:00:00> ATM: Detected
01/01/1970 00:00:00> ATM: Setting up vcc0, VPI=0, VCI=33
01/01/1970 00:00:00> Initialized Dynamic NAPT.
01/01/1970 00:00:00> CfgMgr: 'Shtm.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'ShtmMib.dlz' module loading failed.
01/01/1970 00:00:06> CfgMgr: 'Washer.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Apimage.dlz' module loaded.
01/01/1970 00:00:06> CfgMgr: 'Prism.dlz' module loaded.
01/01/1970 00:00:17> ATM Connected
01/01/1970 00:00:17> ATM layer is up, cell delineation achieved
01/01/1970 00:00:17> ADSL connected
01/01/1970 00:00:17> Modulation: G.dmt
01/01/1970 00:00:17> Annex Mode: ANNEX_B
01/01/1970 00:00:17> Max Tx Power: -38dBm/Hz
01/01/1970 00:00:17> CO Vendor: UNUSED_VENDOR_0
01/01/1970 00:00:17> d/s SNR: 30.6dB, u/s SNR: 12.0dB
01/01/1970 00:00:17> d/s Attenuation: 26.5dB, u/s Attenuation: 14.5dB
01/01/1970 00:00:17> d/s Data Rate: 1024kbps, u/s Data Rate: 256kbps
01/01/1970 00:00:17> d/s Latency: FAST, u/s Latency: FAST
01/01/1970 00:00:17> d/s total bit capacity: 2131bits, used: 312bits
01/01/1970 00:00:17> u/s total bit capacity: 72bits, used: 72bits
01/01/1970 00:00:17> ATM Tx Error Count: 0, Rx Error Count: 0
Kaj se desi ak kliknes na ovo pod firmware?
Ak oces da jos neke setinge usporedimo, jesi puno čačko po drugim setinzima prije?
jako ti je čudna vrijednost signal šuma SNR tak di ja imam 30 ti imas 11?, i to je baš download SNR...
Atenuacije nisu isto skroz isto podesene al mislim da to ne bi trebalo bit od bitne razlike.
