Sad-da li je BIOS ili nekaj drugo, ali meni je ovako rekao inžinjer firme od koje sam kupio ploču:
For the best guarantee that everything works properly:
Unplug the power cord to the computer to completely power down
clear CMOS jumper for 30 seconds
Power computer back up, and immediately go into the BIOS
Choose "Load Failsafe Defaults" or "Load Optimized"
Save and exit
Immediately after reboot, go back into the BIOS and configure to your liking
Clearing CMOS after a flash helps clear any old settings in the BIOS that might conflict with the new BIOS codes.
Always remember to completely power down the board by removing the computer's power cable or the motherboard's ATX power block plug before clearing the CMOS jumper.