View Single Post
Staro 09.10.2003., 21:51   #1
Overvide
Premium
 
Datum registracije: Sep 2003
Lokacija: Zagreb
Postovi: 537
**Abit NF7-S Beep Codes

++++++++++++++++++++++++++++++++++++++++++++++
**Abit NF7-S Beep Codes
Basic Beep Codes for ABIT AWARD BIOS Motherboards

No beep at all - this means your motherboard is dead, either due to a defective or underpowered power supply, poorly seated CPU or RAM, or a dead-on-arrival board


One beep - board is working fine


One long beep then machine shuts down - faulty, improperly installed or missing CPU


1 short(Beep) System booting is normally


2 short(Beep) CMOS setting error


1 long - 1 short(Beep) DRAM ERROR


1 long - 2 short(Beep) Display card or monitor connected error


1 long - 3 short(Beep) Keyboard Error


1 long - 9 short(Beep) ROM Error


Long(Beep) continuous DRAM isn't inserted correctly


Short(Beep) continuous POWER supply has a problem


A two-tone siren, generally caused by overheating or out of specification voltages
++++++++++++++++++++++++++++++++++++++++++++++

Four beeps then machine shuts down. This is because this version of the BIOS will shut down your machine if no fan tachometer signal is detected on the fan header. Make sure you attach a fan to the FAN1 or FAN4 header or clear CMOS to reset to default (no checking).


Ovo je sa abitovog foruma.Znam da je netko pitao da li abit ima neki dijagnostički sustav.Neda mi se ovo prevest jer već jednom jesam ali je pukla veza sa internetom i cijeli se post izbrisao.
Overvide je offline   Reply With Quote