[tintin]

Zezao sam se danas sa bed levelingom...
Najbolje što sam uspio dobiti je ovo, pa me zanima da li da ostavim tako ili moram još probati poravnati?
Printer je Ender3 V3 KE

## [bed_mesh default]
## version = 1
## points =
##       0.210000, 0.167500, 0.092500, 0.045000, 0.037500, 0.097500
##       0.117500, 0.057500, 0.035000, 0.007500, 0.020000, 0.100000
##       0.025000, 0.010000, 0.005000, 0.015000, 0.060000, 0.100000
##       0.015000, 0.015000, 0.040000, 0.052500, 0.075000, 0.140000
##       0.032500, 0.032500, 0.050000, 0.080000, 0.140000, 0.245000
#*#      0.200000, 0.132500, 0.155000, 0.205000, 0.277500, 0.410000