PC Ekspert Forum - View Single Post

ICT Avatar · 23.02.2024., 17:50

Zamjena senzora rješava problem barem u mojem slučaju, do tada ga trebaš isključiti kroz menu
jedino što još možeš probati
I was having the issue "printer asking you at the beginning of a print to unload the filament and then to load it back in". The issue ended up being that the printed part that holds the ball became worn down over time and the filament wiggled inside enough that the sensor did not work correctly. I ended up re-printing this part - https://github.com/prusa3d/Original-...er-printer.stl
The sensor is working perfectly now after reassembling it! Hope this helps others that may be having the same issue!
https://help.prusa3d.com/article/ir-...5s-mk3s_112226
https://www.youtube.com/watch?v=LJHUcgUcsQE

23.02.2024., 17:50	#171
ICT Avatar Premium Datum registracije: Dec 2014 Lokacija: Area 51 Postovi: 199	Zamjena senzora rješava problem barem u mojem slučaju, do tada ga trebaš isključiti kroz menu jedino što još možeš probati I was having the issue "printer asking you at the beginning of a print to unload the filament and then to load it back in". The issue ended up being that the printed part that holds the ball became worn down over time and the filament wiggled inside enough that the sensor did not work correctly. I ended up re-printing this part - https://github.com/prusa3d/Original-...er-printer.stl The sensor is working perfectly now after reassembling it! Hope this helps others that may be having the same issue! https://help.prusa3d.com/article/ir-...5s-mk3s_112226 https://www.youtube.com/watch?v=LJHUcgUcsQE Zadnje izmijenjeno od: ICT Avatar. 23.02.2024. u 18:00.