View Single Post
Staro 14.06.2017., 09:23   #2
Imagine
undercover
Moj komp
 
Imagine's Avatar
 
Datum registracije: Oct 2006
Lokacija: u raljama ovisnosti
Postovi: 1,407
Kako se to uspilo 'zmrdat'?

Ne odgovara ti igranje s konvergencijom iz menija?

Po defaultu te opcije nema na nekim Epsonima 9k pa se mora iz servisnog menija.

Citiraj:
1. Switch on the PJ

2. Press and hold the Menu-Button for 8 sec.

3. Press the ESC-Button twice

Now a new Window with Informations about the Beamer appears. With the
"Arrow-right" and "Arrow-left"-Button you can see several other Information-Windows.

4. Press again the Menu-Button for 8 sec.
5. Press again the ESC-Button twice.

Now a new Windows appears. On the left side you see 6 lines named
"DIP-SW1" to "DIP-SW 6". Move with the "Arrow-down-Button" to "DIP-SW 6" and press "Enter".

On the right side there are 8 lines named "Bit 0" to "Bit 7" and then "0" and "1" with a white (=deactivated) or green (=activated) Rectangle before the 0 or 1.

Move now with the "Arrow-down"-Button to the line named "Bit 5" and then activate with the "Arrow-right"-Button.

Don't change other bits or DIP-Switches!

Now press Enter and then leave the menu by pressing ESC twice.

Now switch off the PJ and then on again.

Now you can find a new submenu named "LCD Alignment" in the "Advanced"-Submenu. Here you can adjust the pixel alignment, you can activate or deactivate the adjustments or reset them.

The "LCD Alignment"-submenu will appear now permanently in the "Advanced"-Submenu until you deactivate "Bit 5" in DIP-SW 6.
Kako
__________________
if you build it they will come
Imagine je offline   Reply With Quote