Citiraj:
Originally posted by mc_fish
misliti je drek znati
|
Iz enciklopedijskog rječnika:
Citiraj:
|
misliti= radom MOZGA oblikovati misao, oblikovati pojmove i sudove; rasuđivati, zaključivati
|
Osnovna škola.... Ili... Vrtić??? Hmm... Neću komentirat jer bi sve bilo suvišno!
Citiraj:
Originally posted by mc_fish
ajmo sad redom...vidio si kolko je zalman dobar kao stok kuler
npr...sam jedan primjer kaj sam vam rekao...al ne bi vi slusali?ma ne vi ste najpametniji
|
Joj sry "GODSEND" poonizno stojim pred tobom!
Citiraj:
|
If you are looking for the quietest air-based CPU cooler possible for your high end Athlon FX or P4, it is quite obvious that the CNPS7000-Cu is the best solution.
|
ČITAJ SVE:
Citiraj:
|
The Epox 9NPA+ Ultra is a fast and overclocker friendly motherboard that has a price most users will be able to accept.
|
Citiraj:
Originally posted by mc_fish
to se tice ocz-a ok sta vidio si da je gote utt chip i sad je to mrcina?daj mu vise od 3.3 na duze vrijeme i vrisnut ce
cl2.5 zaboravi odma jer winbond chipovi (a sada ih proizvodi infinion-to ste isto znali)radi samo i iskljucivo na cl 2
|
Citiraj:
|
As you already know the OCZ DDR PC-3200 gold memory modules use Winbond BH5 chips. These chips are known for ultra low latency (2-2-2-5, 1T) timings. They are also known for their ability to respond well to higher voltages than most chips. This leads to my goal in this review; to show the memories ability to overclock with ultra tight 2-2-2-5 timings at different voltage increments.
|
Citiraj:
|
“I want to thank Etrememhz for taking the time to review the OCZ PC3200 Gold memory. This product uses Winbond BH chips. The nature of these chips is such that they do very tight 2-2-2 timings at 200mhz with 2.8v, yet for a good overclock at 2-2-2 timings, they generally require 3.4v to 3.5v. It has been well documented that the IC7 Max3 board, which is now about 2 years old, does not track Vtt voltage with Vdimm. Vtt must remain at 1/2 of Vdimm to allow the voltage to be of any use. Raising the Vdimm past 2.9v leaves Vtt at 1.4v and the extra voltage only causes instability and provides no gain. The fact that 210mhz was the maximum overclock on a stock IC7 Max3 is not surprising. Testing on a more modern platform such as AMD A64 with a board the can provide the required voltage or using a DDR booster will yield much better overclocking results.”
|
Znam ti ja čitati nisam retardiran...
Citiraj:
|
i jos jedna za kraj vezana uz links...ako mi pokazes jedan bilokoji ducan kojic e bolej od njih slozit konfu od linksa kupim ti 2 gajbe pive
|
ALIENWARE p.s. ne pijem pivu može neka žestica?