The mainboard supports ATX power supply for the power system. Before inserting
the power supply connector, always make sure that all components are installed
properly to ensure that no damage will be caused.
PIN SIGNAL
13 +3.3V
14 -12V
15 GND
16 PS-ON#
17 GND
18 GND
19 GND
20 Res
21 +5V
22 +5V
23 +5V
24 GND
PIN SIGNAL
1 +3.3V
2 +3.3V
3 GND
4 +5V
5 GND
6 +5V
7 GND
8 PWR OK
9 5VSB
10 +12V
11 +12V
12 NC
Pin Definition
ATX 24-Pin Power Connector: ATX1
This connector allows you to connect an SSI power supply. To connect the
SSI power supply, make sure the plug of the power supply is
inserted in the proper orientation and the pins are aligned. Then
push down the power supply firmly into the connector.
You may use the 20-pin ATX power supply or 24-pin SSI
power supply as you like. If you’d like to use the ATX power supply,
please plug your power supply along with pin 1 & pin 13 (refer to
the image at the right hand). There is also a foolproof design on pin
11, 12, 23 & 24 to avoid wrong installation.
sastavljao sam komfu s maticnom MSI k8 neo4, i neradi, sve vrti nema slike, pa me buni ovo oko napajanja kad stavim napajanje s 24 pinskom uticnicom u maticnu ono drugo 4 pinsko sto bi trebalo napajati cpu neide unutra, nece da sjedne ,, ako stavim 20 pinsko onda na tom napajanju ide to 4 pinsko za cpu (dvije zute i dvije crne), ali komp neradi,,
probao sam mjenjati komponente i nista,, ispraznio bios i opet nista jednostavno komp radi al nema slike, mijenjao grafe (rade na drugom ovdje nemaju slike,, vrti hlađenje grafe),, ispirio sam utore za grafu ,, opet nista,, isto napravio s ramom i nema efekta,, pa na kraju sam pomislio da je mozda to napajanje,, al vraga probao i drugo i opet nista,, a radi na drugom kompu,, jedino me buni sto kad ga spojim na struju odmah zavrti , pospajao sam sve swicheve po manualu, rade normalno al prvo pokretanje odmah krene bez obzira sto nisam stisnuo power,, dakako najveci je problem sto nema slike na monitoru!