radi monitor sa bios 3.10 od asrock 890gx ex.3 ali mi javlja ovaj error 1394 guid are invalid in both cmos and flash kada upalim kompj. pa sam googlao i pronasao rijesenje ali ne shvacam jedan dio:
If 1394 ID was error, please refer attachment tool to fix it.
Please refer below steps to input motherboard＇s 1394 ID.
STEP1: Find motherboard＇s 1394 ID on FLOPPY1 connector and write it down. (Yellow tab)
STEP2: Unzip attachment zip file to a bootable Floppy diskette.
STEP3: After entering pure DOS environment, key in “fwguid c [1394 ID], press ENTER.
After updating 1394 ID successfully, monitor will print “Write GUID function call OK＂ message on screen. (1394 ID is 8 byte serial number. Ex: 00138F0000000091).
STEP4: Reboot your system.
l If you did not have floppy drive, you could use bootable USB pen driver to fix it.
ne kuzim step 2 - bootable USB pen? sta je usb pen? je li to obicni usb stick i kako da on bude bootabilan <- pogotovo me zanima
edit: skuzio