hmm, onda bi trebalo raditi. Mislio sam da si ostavio na Auto a tada se onboard grafa gasi ako je druga spojena u neki od PCI/PCIe utora.
Jesi li probao postaviti onboard grafu za primarnu ili se pozabavit tim postavkama?
Ovo je postupak za omogućit surround ali ne znam zašto tebi ne šljaka. Nije iz manuala za tvoju ploču no princip je taj.
Citiraj:
1. Install the ATI PCI Express VGA cards on PCIE slot
2. Connect D-Sub monitor cable to VGA port on the I/O panel. And connect other
monitor cables to the corresponding connectors of the add-on PCI Express
VGA cards
3. Boot your system. Press to enter BIOS setup. Enter “Share Memory”
option to adjust the memory capability to [32MB], [64MB], [128MB] [256MB] or
[512MB] to enable the function of VGA. Please make sure that the value
you select is less than the total capability of the system memory. If you do not
adjust the BIOS setup, the default value of “Share Memory”, [Auto], will disable
VGA function when the add-on VGA card is inserted to this motherboard.
4. Install the onboard VGA driver and the add-on PCI Express VGA card driver to
your system. If you have installed the drivers already, there is no need to install
them again.
5. Set up a multi-monitor display.
|