Citiraj:
Autor Burko
ili negdje postoji jumper kojim se prebacuje zvuk naprijed/straga na ploci. ili driveri nisu "sjeli" kako treba, instalirani su ali ne funkcioniraju..........
uglavnom, osobno bi probao XP, nasao drivere preko deviceID-a, pregledao plocu za front audio jumpere i tek onda vidio sto je.
|
Puno hvala korisniče Burko na savjetu. Nakon podužeg kopanja po webu naletio sam na text:
Most front Panel audio headers conform to the Intel standard this has 10 positions in two blocks of 5. These blocks are numbered 1,3,5,7 and 9 and 2,4,6,8 and 10. Each of these positions has a pin on it except for position 8 which is empty.
Your diagram is upside down. Pin 1 is your MIC2 and Pin 2 is your AGND. One thing on the list of connectors you have two RETURN Rs. One of these should be RETURN L.
Your connectors should be attached as follows:
Pin 1 - MIC IN PIN 2 - GND
PIN 3 - MIC PWR PIN 4 - No connector
Pin 5 - SPKOUT R PIN 6 - RETURN R
Pin 7 - Not used Pin 8 - No Pin
Pin 9 -SPKOUT L Pin 10 - RETURN L
The jumpers on pins 5 & 6 and 9 & 10 are required if front panel audio is not connected. The jumpers are required for the signal output to be sent to the rear audio ports. Otherwise the rear Line Out connection will not work.
If your connecting front panel audio you remove the jumpers
Hope this helps
Na mojoj ploči nije bilo nikakvih jumpera na FP_audio pa sam stavio dva jumpera na 5-6 i na 9-10 pinove. Uglavnom zvuk je proradio.
