Prvi problem je šta proizvođači opreme ponekad namjerno u postavkama wirelessa definiraju parametar kojim ograničavaju povezivost samo na "svoje" uređaje tj. istog proizvođača.
Drugi problem može biti / je presiromašni web konfig ST780WLi, WDS ima / treba parametre koje treba postaviti a ne samo on/off. Moguće je da se to može napraviti kroz CLI ali nije jednostavno i dostupno svakom.
U postavkama D-Linka trebaš / možeš postaviti:
- postavi IP uređaja na 192.168.1.2 obzirom da je ST780WLi na 192.168.1.1
- isključi DHCP (napiso si da već jesi)
- postavi DNS na manual i to Primary=192.168.1.1, Secondary=195.29.150.3 (DNS T-Coma)
- u vezi pitanja WDS moda rada pogledaj
ovo uputstvo (nebitno šta se radi o drugom uređaju). Copy - Paste objašnje za WDS mode rada:
Code:
Bridge Mode
In bridge mode, the access point communicates only with other access points.
No wireless clients can associate with an access point in bridge mode. In bridge
mode, the access point has the option of acting as a Root (click the Activate
as Root box to enable). In Root mode the AP becomes a primary link for the
Wireless LAN to the Ethernet and Internet. As the Root access point, there
cannot be a wireless Uplink through the AP. Only wireless Downlinks may be
designated. To designate a Downlink, enable up to 4 downlinks (Downlink 1 – 4)
and type the MAC address of the AP used for downlink in the space provided.
Use Bridge mode if you are using the access point to connect to a distant
Ethernet LAN.
Repeater Mode
In repeater mode the access point can communicate with other access points
and wireless clients. Note that repeater mode will limit the amount of throughput
of wireless clients to the Ethernet. As with bridge mode, repeater mode allows
the AP to function as the Root.
Crude Mode
Crude Mode is recommended for wireless LANs using multiple vendors wireless
chip solutions. If wireless stations are using TI chips, use Bridge or Repeater
mode.
Po tome probaj Repeater ili Crude mode.
- tebe interesira Uplink polje tj. tu unosiš MAC adresu wirelessa na ST780WLi (vidi se u web konfigu a možeš provjerit sa nekim laptopom). Zašto Uplink? Zato jer je ST780Wli po mrežnoj topologiji "gore" i prema netu (vrlo pojednostavljeno rečeno al dovoljno da razumiješ(te).
Slijedeće nije neophodno al može pomoći:
- dodaj manual Route na ST780WLi (Advanced - Routing Table), Destination=0.0.0.0, Subnet=255.255.255.0, odaberi Gateway i unesi 192.168.1.1
- možeš isključit (Disable) sve Pvc jer ne koristiš adsl modem a ovim ćeš izbječi error logove
Nezaboravi na svakom ekranu "lupit" Applay i Save And Reboot na Tools tabu.
U web konfigu ST780Wli provjeri jeli se D-Link uspio spojiti.
Javi rezultat.