Dakle skrpao sam staru zvijer i imam problem.
http://forum.pcekspert.com/showthread.php?t=133042
Naime komp normalno ugasim na shutdown u WinXP, ali pila i dalje radi, svijetli zelena LEDica i svi ventovi se vrte, kao da je nešto enejblano u BIOSu, a ja se više ne sjećam što bi to moglo biti, jebiga...ako netko zna nek pomogne
Da nije nešto od ovoga iz PowerManagement dijela AMI BIOS-a? Meni je po defaultu APM/ACPI enejblan.
Citiraj:
Power Management Setup Page
This page sets some of the parameters for system power management operation.
AMIBIOS SETUP – POWER MANAGEMENT SETUP
©1998 American Megatrends, Inc. All Rights Reserved
Power Management/APM Disabled
Standby Time Out (Minute) Disabled
Suspend Time Out (Minute) Disabled
Ring On Power On Disabled
LAN Card Power On Disabled
RTC Alarm Power On Disabled
RTC Alarm Date 15
RTC Alarm Hour 12
RTC Alarm Minute 30
RTC Alarm Second 30
ESC : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift)F2 : Color
F6 : Load Optimal values
F7 : Load Best performance values
Power Management/APM Use this item to enable or disable a power management scheme. If you enable power management, you can use the items below to set the power management operation. Both APM and ACPI are supported.
Standby Time Out (Minute) This sets the timeout for Standby mode in minutes. If the time selected passes without any system activity, the computer will enter power-saving Standby mode.
Suspend Time Out (Minute) This sets the timeout for Suspend mode in minutes. If the time selected passes without any system activity, the computer will enter power-saving Suspend mode.
Ring On Power On The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is an incoming call on the Fax/Modem. You must use an ATX power supply in order to use this feature.
LAN Card Power On The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is traffic on the network adapter. You must use an ATX power supply in order to use this feature.
RTC Alarm Power On The system can be turned off with a software command. If you enable this item, the system can automatically resume at a fixed time based on the system’s RTC (realtime clock). Use the items below this one to set the date and time of the wake-up alarm. You must use an ATX power supply in order to use this feature.
|