Citiraj:
Autor Bravo
Na dfi p35-t2rs sam ga u par koraka stavio na 4.4Ghz i izvrtio superpi na 1.44v vcore..Dok na biostarki nemogu izvrtit pi niti na 4.2Ghz..
Code:
Code:
>CPU Configuration
C1E Support........................Disabled
Hardware Prefetcher................Disabled
Adjacent Cache Line Prefetch.......Disabled
Max CPUID Value Limit..............Disabled
Intel Virtualization Tech..........Disabled
CPU TM function....................Disabled
Execute-Disable Bit Capability.....Disabled
Core Multi-Processing..............Disabled
Intel C-STATE tech.................Disabled
>O.N.E.
Over-Clocking Navigator............Manual
Intel SpeedStep tech...............Disabled
Ratio CMOS Setting.................X6.0
CPU Frequency......................460
Over Clock Retry Count.............1
FSB To NorthBridge Latch...........Auto
DDR Frequency......................DDR2 920Mhz
DDR2 Enhance Mode..................Disabled
>Voltage Configuration
CPU Volttage.......................+0.2875v (1.496v)
DDR Volttage.......................+0.200v
Chipset Volttage...................+0.500
FSB Volttage.......................+0.400
CPU1 GTL...........................0.63x
CPU2 GTL...........................0.63x
MCH GTL............................0.59x
CPU PLL............................1.6v
ISL6322 Frequency..................Nominal
CPU Clock Skew Control..................200ps
MCH Clock Skew Control..................400ps
|
Zakaj ti je Core Multiprocessing ugašen?
Zašto si pobogu nakrkao 1,6V na CPU PLL za E8400?
Ja sam, ako se dobro sjećam, navukao E8500 sa TPower na 500MHz FSB-a sa tek blagim podizanjem napona za Chipset i FSB