Mislim stvarno je bilo teško naslov topica uvalit u
i u 5. linku naći:
HP-LJ4200/4300 Reset indication service after replacing Maintenance Kit
After a maintenance kit is installed, the maintenance-kit counter must be reset. Use the following procedure to reset the maintenance-kit counter.
1. Turn the printer power off.
2. Hold down the SELECT ( ) button, and then turn on the printer power. Continue holding down the SELECT ( ) button until all three printer control-panel lights flash once and then remain on. This might take up to 10 seconds.
3. Press the UP ARROW ( ) button to scroll to NEW MAINTENANCE KIT.
4. Press the SELECT ( ) button to reset the maintenance-kit counter.
Note. Perform this procedure only after a maintenance kit has been installed.
Do not use this procedure to clear the PERFORM PRINTER MAINTENANCE message temporarily. Do not use this procedure to clear the PERFORM PRINTER MAINTENANCE message temporarily.