Speedtouch bandwitdh limit CLI
 

Poz ekipi s foruma. Radi se o t-comovom thompson speedtouch st780wl routeru vjerojatno vecini svima poznat. Pokusavao sam pronaci da li se na koji nacin moze na njegovim interface-ima, tj. pojedinim portovima ograniciti bandwitdh no bas kad sam se ponadao da ce sve raditi eto problema..

Komande koje bi to trebale omogucit su:

eth switch shaper config


shaper -> The shaper instance.
control -> Shape MAC control traffic.

eth switch shaper ifconfig

Citiraj:

eth switch shaper ifconfig port = number{1-4} ingress = {enabled|disabled} shaper = number{0--1} [state = {enabled|disabled}] [speed = number{64000-100000000}]> [burstsize = <{}]>

port -> The port. REQUIRED
ingress -> Ingress port = enabled; egress port = disabled. REQUIRED
shaper -> The shaper instance. REQUIRED
state -> Enable/disable shaping. OPTIONAL
speed ->Speed in bits/sec. OPTIONAL
burstsize ->Burst size in KBytes. OPTIONAL

No medjutim kad se pokusa konfigurirat "switch shaper" on javlja poruku tipa: Shapers are not supported by the onboard switch.

Do firmware-a ne bi trebalo biti, jedino do router hardwera.. toliko o tome kakve routere t-com izdaje, vjerojatno neka kineska roba a ne original pa zato i ne radi jer po svemu - trebalo bi radit kad ove komande stoje u official dokumentaciji routera.

Da li je netko ovo vec pokusavao i da li netko od iskusnijih ima mozda jos kakav prijedlog?:stoopid: